In terms of technological development, the mode of relying on the automation of equipment for production will eventually replace the mode of relying on individual manual cumbersome operations. Therefore, the in-machine tool setting instrument is an inevitable direction of development.

However, due to the current low productivity of our country and the indifference to people's lives and health, most machining centers do not use tool setting instruments or configure tool setting instruments. To produce high-grade products, in addition to good machine tools, good auxiliary equipment, such as tools, tool setting tools, workpiece probes, etc., are also required. It seems that only the Maxima still can't run fast, and it needs a saddle to surpass the initial state of streaking.

The machining center recommends the German M & H tool setter 38.10 and the workpiece probe 40.01-RX / TX. I have used it before and it is very good. 38.10 In addition to the length of the tool, it can also detect the diameter and wear of the tool and the breakage of the small tool. By the way, M & H is now a subsidiary of Hexagon. Compared with everyone who has Hexagon's CMM.